GOES-17 Low-level (7.3 µm), Mid-level (6.9 µm) and Upper-level (6.2 µm) Water Vapor images [click to play animation | MP4]
* GOES-17 images shown here are preliminary and non-operational *
GOES-17 Low-level (7.3 µm), Mid-level (6.9 µm) and Upper-level (6.2 µm) Water Vapor images (above) revealed an interesting train of standing waves about 100-150 miles south of the Big Island of Hawai’i on 25 November 2018. With the presence of moisture aloft, the 3 water vapor weighting functions — calculated using the 00 UTC Hilo sounding — were shifted to high enough altitudes to eliminate the sensing of radiation from features in the lower troposphere. There were no pilot reports of turbulence in the vicinity of these waves — but they were located outside of the primary commercial air traffic corridors to/from the islands.
GOES-17 “Clean” Infrared Window (10.3 µm) and Near-Infrared “Cirrus” (1.37 µm) images (below) showed that these middle/upper-tropospheric clouds (likely cirrus) were radiometrically transparent to thermal energy being emitted from near the surface — marine boundary layer stratocumulus clouds could be seen drifting westward within the easterly trade wind flow. As a result, the satellite-sensed 10.3 µm infrared brightness temperatures of the standing wave clouds were much warmer than that of the air at higher altitudes where they existed. However, these standing wave features were very apparent in the 1.37 µm Cirrus imagery, along with what appeared to be other thin filaments of cirrus cascading southward overhead. The southward motion of the features seen on Cirrus images suggests that they were at pressure levels of 370 hPa (26,9000 feet or 8.2 km) or higher according to the Hilo sounding.
GOES-17 “Clean” Infrared Window (10.3 µm) and Near-Infrared “Cirrus” (1.37 µm) images [click to play animation | MP4]
A comparison of all 16
ABI spectral bands is shown below. Note that in the longwave infrared bands along the bottom 4 panels, the brightness temperatures are progressively colder
(darker shades of green) on the
11.2 µm,
12.3 µm and
13.3 µm images — each of these bands are increasingly affected by water vapor absorption aloft, therefore more effectively sensing the thin layer of higher-altitude standing wave clouds. AWIPS cursor sampling showed the differences in detected brightness temperature at 3 different points along the feature:
here,
here and
here. The increasing sensitivity to radiation emitted from higher altitudes can also be seen in a comparison of weighting functions for
ABI bands 13, 14, 15 and 16.
GOES-17 images of all 16 ABI spectral bands [click to play animation | MP4]
A toggle between GOES-15
(GOES-West) Visible (0.63 µm), Water Vapor (6.5 µm), Infrared Window (10.7 µm) and Infrared CO2 (13.3 µm) images at 2300 UTC
(below) showed that the lower spatial resolution of the legacy
GOES Imager was not able to adequately resolve the individual waves at that time. As seen with the GOES-17 imagery, the 13.3 µm CO2 brightness temperatures were significantly colder
(shades of blue) compared to those of the conventional 10.7 µm Infrared Window.
GOES-15 Visible (0.63 µm), Water Vapor (6.5 µm), Infrared Window (10.7 µm) and Infrared CO2 (13.3 µm) images at 2300 UTC [click to enlarge]
In comparisons of VIIRS True Color Red-Green-Blue (RGB) and Infrared Window (11.45 µm) images from Suomi NPP and NOAA-20 visualized using
RealEarth (below), note the highly-transparent nature of the standing wave clouds on the RGB images; only the earliest 2256 UTC VIIRS
11.45 µm image displayed brightness temperatures of -20ºC and colder
(cyan to blue enhancement).
Suomi NPP VIIRS True Color RGB and Infrared Window (11.45 µm) images at 2256 UTC [click to enlarge]
NOAA-20 VIIRS True Color RGB and Infrared Window (11.45 µm) images at 2336 UTC [click to enlarge]
Suomi NPP VIIRS True Color RGB and Infrared Window (11.45 µm) images at 0028 UTC [click to enlarge]
So the big question remains:
what the heck is this? Perhaps one clue existed in the winds aloft, as depicted by the NAM at
200 hPa,
250 hPa and
300 hPa (below), which showed northerly/northeasterly flow that was decelerating as it entered a trough axis
(the region within the red box). Could this flow deceleration have induced a “reverse flow” which then caused enough weak lift to form the thin standing wave clouds within the increasingly moist 220-274 hPa layer seen on the
Hilo sounding? No other obvious forcing mechanisms were seen in the immediate area — a slowly-approaching
surface cold front was too far north of Hawai’i to have played a role.
NAM Winds at 200 hPa, 250 hPa and 300 hPa [click to enlarge]
from CIMSS Satellite Blog
http://cimss.ssec.wisc.edu/goes/blog/archives/30824
No comments:
Post a Comment